HVAC Augusta WV

I am a highly skilled HVAC contractor professional. I recently completed a fall maintenance project for a residential customer. The project involved inspecting and servicing the heating and cooling systems, including cleaning the air filters, checking the refrigerant levels, and performing any necessary repairs or replacements. The customer was very pleased with the results and expressed satisfaction with the professionalism and expertise o

I installed a new miller 20 kw electric furnace with a new start relay in a heatpump.

I received a call from a customer who reported that their home's heating system was not working. I arrived at the customer's home and performed a thorough inspection of the system. I found that the furnace was not producing any heat. I diagnosed the problem as a faulty thermostat and replaced it with a new one. After completing the repair, the customer was happy with the results and expressed gratitude for the quick and efficient service.

I recently completed a job as an HVAC contractor. I was responsible for inspecting, cleaning, and repairing the heating and cooling systems of a residential home. This involved checking the electrical connections, inspecting the ducts, and replacing any worn-out pa

I was responsible for performing fall maintenance on an HVAC system. This included cleaning the coils, checking the refrigerant levels, and inspecting the electrical components. I also replaced the air filters and cleaned the blower wheel.

I recently completed an oil furnace maintenance job for a customer. The furnace was over 15 years old and needed a thorough cleaning and inspection. I replaced the air filter, cleaned the burners, inspected the heat exchanger, and checked the electrical components. I also lubricated the moving parts and tested the thermostat to ensure it was worki

I installed a Heil 80,000 BTU 96% efficient propane furnace with a 3-ton 15 SEER AC and match

I installed a new Heil 3-ton air handler with a 10-kw electric heat kit and ran a new high-voltage line with a 60-amp breaker.

I installed a new miller 20 kw electric furnace with a new start relay in a heatpump.

I installed a new Heil 3.5-ton 15-SEER heat pump with matching evaporator coil, a 15-kw Miller electric furnace, and two supply lines to an addition. I also provided a free Honeywell digital thermostat.

I was called to a home to repair an HVAC system that was not working properly. Upon arrival, I found that the compressor was not working, and the system was not cooling the home. I diagnosed the issue as a faulty compressor and replaced it with a new one. After the replacement, the system was able to cool the home again. The homeowner was very pleased with the work and thanked me for my help.

I am a highly skilled and experienced home service professional. I recently completed a job installing a new heating and air conditioning system in a new construction home. It was a challenging project, but I was able to complete it on time and within budget. The new system is efficient and reliable, and the homeowners are very happy with it.

A Lennox XC21 system was showing signs of intermittent cooling due to a refrigerant leak in the evaporator coil. Using a leak detector, I identified the leak and repaired it with a brazing torch. After evacuating the system, I recharged it with R410A refrigerant to the manufacturer-specified levels. Testing confirmed the Lennox XC21 was back to full cooling capacity and proper pressure balance.

Responded to an emergency call for a Trane XR15 unit that wasn’t cooling. Upon inspection, I found the system had completely frozen due to a clogged air filter and low refrigerant levels. After shutting off the unit to allow it to defrost, I replaced the air filter and located a leak in the refrigerant line. Using a brazing torch, I repaired the leak and recharged the system with R410A refrigerant. The Trane XR15 was restored to full cooling capacity and is now operating efficiently.

emergency hvac service

Investigated a no-cooling issue with an HVAC system in Augusta, WV this evening. Found that the thermostat wiring had become loose, causing the unit to shut down. Secured the wiring connections and tested the thermostat for proper communication with the AC system. Verified that the unit is now fully operational, providing consistent cooling as expected.

Responded to a no AC service call. Upon inspection, found a broken duct causing air leakage and a thermostat with depleted batteries. Repaired the ductwork using mastic sealant and reinforced with fiberglass mesh tape to ensure no air leaks. Replaced the thermostat batteries with new AA alkaline batteries. Checked the entire system for proper airflow and ensured the thermostat was functioning correctly. Tested the AC unit to confirm it was cooling efficiently. Advised the homeowner on the importance of regular maintenance to avoid similar issues in the future.

Serviced a York air conditioning system with no cooling issue. Checked power at disconnect and verified 24V control voltage. Used multimeter to test capacitor microfarads and compressor winding resistance within specifications. Inspected contactor for pitted surfaces. Traced low voltage wiring and replaced faulty heat pump reversing valve solenoid coil. Evacuvated system and recharged to manufacturer's recommended charge levels. Confirmed proper cooling operation before departure.

Responded to a service call regarding a lack of heating from a Goodman furnace. Upon inspection, it was discovered that the igniter had failed. A replacement was promptly installed, and the system's heat exchanger was examined for cracks or damage—none found. The furnace was then tested for proper operation, ensuring the thermostat and safety switches were fully functional. The repair restored heat, enhancing the system's reliability and performance during the colder months.

I completed an HVAC repair on a Goodman GSX16 Air Conditioner. The job involved diagnosing a refrigerant leak, which I located and sealed. I then refilled the system with R-410A refrigerant to the manufacturer's specifications. Additionally, I replaced a faulty capacitor (model CAP050350440RSP) to ensure efficient operation. The system's performance was tested to confirm it was cooling effectively and running smoothly.

Hvac install

Just wrapped up an HVAC service call in Augusta, WV. The issue was a malfunctioning blower motor in a Carrier Infinity system. After a thorough diagnosis, I found a faulty capacitor causing the problem. Replaced it with a new one and ensured all connections were secure. System's up and running smoothly now, providing optimal comfort.

Hvac new construction